RC track-mounted tool handling platform China manufacturer factory distributor

When people look for outdoor power equipment, they often start by listing their specific needs. For some, the priority is handling steep slopes without risking personal injury. For others, the main concern is covering a large area quickly while keeping labor costs under control. There are also those who need a single machine that can work in summer and winter, switching between grass, heavy brush, and snow. The RC track-mounted tool handling platform from Vigorun Tech is designed with these varied requirements in mind.

Radio Controlled Tools Carrier China manufacturer factory distributor

The drive system includes a noteworthy mechanical feature. Each walking motor is integrated with an RV063 worm gear reducer. Worm gears have a characteristic that sets them apart from other gear types: they can be self‑locking. In this design, when power to the motor is cut off, the high friction between the worm and the worm wheel prevents the motor shaft from turning. This means that if the mower is on a slope and the operator releases the controls or the power is interrupted, the machine is less likely to slide or roll downward on its own. It is important to clarify that this self‑locking mechanism does not replace common safety practices, such as parking on level ground when possible or using additional chocks on extreme inclines.

In terms of productivity, the mower travels at a top speed of 4 kilometers per hour. This is not a high speed compared to some ride‑on mowers, but it should be seen in combination with the cutting width. The deck spans 1000 millimeters, or one meter. A wider deck means each pass covers more ground. For an area of one hectare, a 1‑metre‑wide mower moving at 4 km/h would theoretically take about 2.5 hours to complete, assuming no overlaps or obstacles. Actual time will be longer, but the number is still lower than what many walk‑behind mowers with narrower decks would require. Reducing the time spent on mowing can lower labor costs, especially if the operator is paid by the hour. Also, because the machine is remote‑controlled, one person can work from a shaded or safe location while the mower does the physical task. This might reduce fatigue and allow the worker to focus on other duties simultaneously, such as trimming edges or inspecting fences.

Maintenance requirements for this mower would include typical tasks for any tracked vehicle. The rubber tracks need periodic inspection for cuts, cracks, or uneven wear. Track tension might need adjustment. The engine requires oil changes, air filter cleaning, and fuel system care according to the Euro5 specifications. The brushless motors, while low‑maintenance, are not maintenance‑free; their bearings may need lubrication or replacement after many hours of use. The worm gear reducer should have its oil level checked, as worm gears generate more heat and friction than some other gear types, which can degrade lubricant over time. The self‑locking feature relies on the condition of the worm and wheel surfaces, so any wear could reduce its effectiveness.

Model	MTSK1000	VTLM800
Mowing method	Flail mower	Rotary mower
Engine / Power	Twin cylinders, 18Kw / 764cc	Single cylinder, 9.2Kw / 452cc
Walking Motor	48V / 1500W servo motor	48V / 1000W servo motor
Cutting Width	1000mm	800mm
Dynamo	56V 6000W	56V 4000W
Battery	48V 45Ah	48V 20Ah

We are looking for agents, distributors and dealers of RC track-mounted tool handling platform all over the world. If you have any further inquiries or require assistance, please do not hesitate to contact us.